User's Manual

English
24
•Tap Install at the bottom of the screen. The CAB file is
being installed.
• Go back to your computer and click OK to close the
message window and proceed. The installer on the
computer then runs the same sequence as the previous
one, this time to copy the MobileMapper Field installation
files to the receiver.
• Again, a message on the computer tells you to check the
receiver screen. Click OK then Close to complete the
installation on the computer side.
• As previously, the receiver asks you to choose the location
where to install the MobileMapper Field files. Choose the
same location as before for the Ashtech Required
Data.CAB file and tap Install.
Wait until the installation is complete. The receiver then
re-boots automatically. Once re-booted, the MobileMapper
Field option can be seen on the Start screen.
Entering the Activation Code
You will not be able to use MobileMapper Field until you enter
an activation code. This code can be seen on the adhesive
label placed on the MobileMapper Field CD box. This code
was generated from the serial number you provided to
Ashtech when ordering the software. To enter the activation
code:
• Tap on the “MobileMapper Field” line on the start screen.
A message is displayed showing the serial number of your
receiver and a blank activation code field.
• Type your activation code in the blank field.
•Tap OK to validate the code entry. If the “serial number/
activation code” pair matches, then MobileMapper Field
is normally started right after tapping OK.
Getting Started
With
MobileMapper
Field
Launching MobileMapper Field
From the Start screen, tap Start>MobileMapper Field or tap
MobileMapper Field on the Today screen. The main
MobileMapper Field window is described below.