User's Manual

English
45
• Later when you are ready to resume data logging, go back
to where you left the line or polygon, tap Menu>Resume to
continue the data logging as you walk along the feature.
Double Logging
While logging a line or polygon, you may want to log another
feature found along the way, whether a point, a line or a
polygon. Follow the instructions below.
•Tap Menu>Pause to pause the data logging of the feature
in progress.
• Move to the second feature you want to log.
•Tap Log, select the layer of the second feature, make the
necessary settings and log this feature as you would in the
usual case.
•Tap Menu>Stop when you are finished with the logging of
the second feature.
• Go back to where you left the first feature.
•Tap Menu>Resume to continue with the logging of the first
feature.
•Tap Menu>Stop when you are finished with the logging of
the first feature.
More about Feature Logging
• The number of point features that can be logged in a
session is only limited by the memory capacity of the
storage medium used.
• Up to 10,000 points can be logged in a single line or
polygon.
• When logging a long line or polygon, MobileMapper Field
will automatically save the data to a temporary file every
10 minutes of data logging.
If a power failure occurs while logging a line or polygon,
the feature is automatically saved before the power
failure. Because line and area features are saved
automatically every 10 minutes of actual logging, if a
power failure occurs unexpectedly and you have been
logging a line or polygon feature for the last 15 minutes,
then most probably only the first 10 minutes of the feature
will be saved.
• If MobileMapper Field fails to save a feature because
there is not enough memory left, you can still delete
unnecessary files and try again. Follow the instructions
below when this happens.
– Minimize MobileMapper Field