User's Manual
Table Of Contents
- What is MobileMapper 100?
- First-Time Use
- Unpacking
- Charging the Battery for the First Time
- Inserting the Battery Into the Receiver
- Turning the Receiver On
- Adjusting Backlight Level
- Setting Backlight Idle Time
- Power Management
- Regional Settings
- Locking the Screen and the Keypad
- How to Hold the Receiver
- Switching to Suspend Mode
- Turning the Receiver Off
- System Description
- Special Features
- Using MobileMapper Field Software
- Post-Processing Option and MobileMapper Office
- GNSS Toolbox
- Installing Geoids
- Platform Specifications
English
55
– [6]: Observation times covered by the raw data files
added to the project. A green bar stands for a receiver
raw data file, and a yellow bar, for a base raw data file.
• Click and select Open. Browse to the folder
containing your field data files.
• Select the Map file and click Open. MobileMapper Office
shows the content of the project in areas [3], [4] and [5]
(see screen above).
• Click on Add Rover Raw Data. Select the raw data file
corresponding to the project (from the same folder as
previously) and click Open. MobileMapper Office imports
the GRW file and then shows the file properties in areas
[5] and [6]:
• Assuming you are working with a third-party reference
station, click successively on Add Reference Raw Data then
From Web. A new window then opens in which you have to
indicate how you wish to search for the reference station
you will use for post-processing your job.
• Choose one of the following two search criteria:
– Search up to x stations: Specify a preset number of
stations you want to list before choosing one. All the
listed stations will be the closest to your working area,
but there is no range limit for these stations.
– Search up to x km: Specify a limit of distance between
your working site and the stations. The shorter the
distance, the better the raw data from the station, but
the smaller the number of stations that can potentially
be used.
• Click Search, then wait until the search is complete. At the
end of the search, MobileMapper Field lists the stations
meeting the search request.