User's Manual
Table Of Contents
- What is MobileMapper 100?
- First-Time Use
- Unpacking
- Charging the Battery for the First Time
- Inserting the Battery Into the Receiver
- Turning the Receiver On
- Adjusting Backlight Level
- Setting Backlight Idle Time
- Power Management
- Regional Settings
- Locking the Screen and the Keypad
- How to Hold the Receiver
- Switching to Suspend Mode
- Turning the Receiver Off
- System Description
- Special Features
- Using MobileMapper Field Software
- Post-Processing Option and MobileMapper Office
- GNSS Toolbox
- Installing Geoids
- Platform Specifications
English
64
Connection Using an External Mobile Phone on page 16 for
CDMA.
NMEA Output
•Open the GNSS Toolbox and tap on Differential Mode.
•On the NMEA Output tab, select the output port (COMx)
and choose a baud rate for that port.
Read the port allocation table below to select the right
port. Baud rates range from 300 to 115200 Bd.
•On the Messages tab, select the NMEA messages you want
to output. For each message, the output rate can be set to
one of the preset values ranging from 1 second to 1
minute. The available NMEA messages are GGA, GLL,
GSA, GSV, RMC, RRE, VTG and ZDA.
GNSS Status •Open the GNSS Toolbox and tap on GNSS Status.
ISP data required: APN, user, password,..
Connect to Network ..
Modem connection used: Cellular line (GPRS)
Activate Phone function
Insert SIM card
Modem connection used: via Bluetooth
ISP data required: APN, user, password,..
Bluetooth Connection between
Receiver and External CDMA Mobile Phone
(under construction)
Virtual Port Physical Output
COM1-COM4 Reserved. Please do not use these ports.
COM5 DB9 connector on docking station (RS232)
COM6 Reserved. Please do not use this port.
COM7
Internal Bluetooth port used by Bluetooth for
Dial-Up Networking (DUN)
COM8-COM9 Reserved. Please do not use these ports.