User's Manual
Table Of Contents
- 12.Users manual-未完.pdf
- 111.pdf
- First-Time Use
- Unpacking
- Inserting the Battery Into the Receiver
- Turning the Receiver On
- Using the AC Adapter to Charge the Battery
- Adjusting Backlight Level and Idle Time
- Power Management
- Setting Time & Date
- Regional Settings
- Locking the Screen and the Keypad
- How to Hold the Receiver
- Using the Quick Toolbar
- Switching the Receiver Manually to Suspend Mode
- Turning the Receiver Off
- Receiver Description
- GNSS Toolbox
- Advanced Features
- Platform Specifications
- First-Time Use
- 15.19; 15.21; 15.105
- 111.pdf
- 15.19; 15.21; 15.105
English
11
GNSS Toolbox
GNSS Toolbox is used to control and monitor important
functions in your receiver. These are listed and detailed
below.
• GNSS Settings: Constellations and frequencies used in the
receiver.
• GNSS Status: Views GNSS reception monitoring screens.
• Reset: Resets the receiver.
• About: Provides the software version of GNSS Toolbox.
GNSS Settings
•Open the GNSS Toolbox and tap on GNSS Settings. This
opens a new window where you can make the following
settings:
– Tracking mode: Only the “GPS L1” option is available,
which means the receiver can only operate from the L1
signal of the GPS constellation.
– Use SBAS check box: Check this box to enable SBAS
reception, clear it otherwise.
– Elevation mask: Any satellite seen from the receiver with
an elevation angle less than the specified elevation
mask will be rejected. “5 degrees” is the default and
recommended value for this parameter.
•Tap OK to confirm your choices and return to the GNSS
Toolbox window.
GNSS Status •Open the GNSS Toolbox and tap on GNSS Status.