User's Manual

12 


GNSS Settings
• OpentheGNSS ToolboxandtaponGNSS Settings.This
opensanewwindowwhereyoucanmakethefollowingsettings:

– Tracking mode: Only the “GPS L1” option is
available, which means the receiver can only
operatefromtheL1signaloftheGPSconstellation.

– Use SBAS check box: Check this box to enable
SBASreception,clearitotherwise.

• TapOKtoconfirmyourchoicesandreturntothe GNSSToolbox
window.

GNSS Status
• OpentheGNSS ToolboxandtaponGNSS Status. 

GNSS Toolbox 
GNSS Toolbox
isusedtocontrolandmonitorimportant
functionsinyourreceiver.Thesearelistedanddetailed
below.
•
GNSS Settings
:Constellationsandfrequenciesusedinthe
receiver.
•
GNSS Status
:ViewsGNSSreceptionmonitoringscreens.
•
Reset
:Resetsthereceiver.
•
About
:Providesthesoftwarever sionofGNSSToolbox.