User's Manual

13

The default Position tab shows the latitude, longitude and
altitudeofthecurrentposition,ascomputedbythereceiver,
as well the  number of satellites used and the currentPDOP
value.

If SBAS is used, the screen also shows the  position status
(SDGPS).
Theunitusedtoexpressthecurrentaltitude(metersorfeet)
dependsontheregion(languageandcountry)youselectedin
Start,Settings,System,Regional Settings.

• TheSatellitestabdisplaysapolardiagramshowingthelocations
intheskyofthetrackedsatellites.Differentcolorsareusedto
displaythenumbersofthevisiblesatellites:

– Yellowcharacters:GPSsatellitesused
– Greycharacters:VisibleSBASsatellites.AlsorejectedGPS
satellites,becauseunhealthyorundertheelevationmask.
• The Signal tab shows the signal level for each of the tracked
satellites:

– DarkbluebarsforallGPSsatellitesused
– RedbarsforallSBASsat ellitesused
– Greybarsforalltracked,butnotused,GPSsatellites
GPSsatellitesarenumberedfrom1to32andSBASsatellitesfrom
120to138.

Reset
•OpentheGNSS ToolboxandtaponReset.Amessagethen
asksyouifyouwanttoresetthereceivernow.Usethisoption
onlyifyouthinkthereceiverisnotworkingproperly.

Using this function results in a cold reset of the receiver.
Throughacoldreset,alltheGNSSsettings,includingalmanac
data,areclearedmakingitnecessaryforyoutorestoreeach
ofthemmanually.Afewminutesareneededafteracoldreset
beforethereceiverisbacktowork.

UsingtheResetfunctionisrecommendedwhenonlytheGNSS
Toolbox (and not other field software) is running on the
platform.

About
ThisfunctionprovidesthesoftwareversionofGNSSToolbox,followed
bytheSpectraPrecisionlegalline.
