User's Manual

2 

• Putthetrapdoorbackintoplacebyfirstinsertingthetwolugs
locatedatthebottomofthetrapdoor. 

•  Thenpushthedooragainstthereceivercaseandrotatethe
twoscrewsbackintheirinitialpositionstosealthebattery
compartment.

Turning the
Receiver On
• 
PressthePowerkey[1]foracoupleofsecondsuntilyoufeel
avibrationinyourhand,thenreleasethekey . 

Letthereceiverrunitsbootsequence.Waituntilthescreen
displaystheWindowsEmbeddedHandHeld

Homescreen.Atthisstage,youmaybeaskedtoinitializethe
receiver(screenalignment,etc.).Justfollowtheinstructions
onthescreentocompletethisstep.

TheoperatingsystemusedinthereceiverisMicrosoft
WindowsEmbeddedHandHeld.Formoreinformationon
howtousethedifferentapplications,youcanvisitthe
Microsoftwebsiteat:

http://www.microsoft.com/windowsembedded/en-
us/windowsembedded-handheld-6-5.aspx 
Dependingonhowlongyourproductwasstoredinitspackage
beforebeingshippedtoyou,theremainingpowerinthebattery
maybetoolowtoallowthereceivertooperateforyourentire
workingsession.Forthisreason,thefirstthingtodoistocheck
thebatterycharge
status: 
• Taponthetitlebaratthetopofthescreen.TheQuickToolbar
appearsjustunderneath.

• Tap on the Battery icon. This opens the Power window and
simultaneouslyclosestheQuickToolbar. 
ThePowerwindowshowsthestatusofthebattery(seealso
Internal Battery on page 13) . If the remaining power is
greater than 50%, then you can use the receiver without
having to charge the battery first (with 50% of remaining
charge,youcanusethereceiverforseveralhours).
Skipthe
[1]