User's Manual

21 ADL Vantage/ADL Vantage Pro/ADL Vantage 35
The following table describes the various functions available, and lists the choices for
each function. The default settings, where applicable, are shown in bold.
Function Description Parameter choices
Device Status Displays radio status and identification
information
Battery status
Serial Number
Owner name
Call sign
Modulation type
Channel bandwidth
Transmitter status
Duty cycle (when a TRIMTALK
protocol is selected)
Internal temperature
Firmware version
Channel / Frequency Displays/selects channel number and
receive frequency
Channel No. and frequency (MHz)
AutoRover (ADL Vantage)
Manual Entry (ADL Vantage)
Ch TX Frequency Displays Tx freq (if different from the
channel’s Rx freq)
Channel No. and frequency (MHz)
Data Protocol Displays/selects data protocol type Trans EOT (End of Transmission)
Trans EOC (End of Character)
Packet Switched
TRIMTALK
™
450S
TRIMMARK
™
II/IIE
TT450S (HW)
TRIMMARK 3
SATEL
Stonex Type 1
Trans FST
Radio Link Rate Displays/selects bit rate for radio
transmission/reception
4800
8000
9600
16000
(not supported in USA)
19200
Repeater Mode Sets the radio to be a repeater
(non-Trimble) protocols
Off (Not a repeater)
On (Is a repeater)
Operation Mode Sets the radio to be a repeater
(Trimble protocols)
Base/Rover
Basw w/ One Rpt
Base w/Two Rpt
Repeater 1
Repeater 2
Sensitivity Displays/selects radio squelch level High (rover)
Moderate
Low (base)