User's Manual

Figure 2 - ADL Vantage Tripod Clip
Data/Power Cable
The ADL Vantage is connected to a data source, such as a GNSS receiver, using a
data/power cable (see Figure 3). This cable is available with different connectors for attaching
to a large variety of data sources. Contact your Pacific Crest sales representative for selecting
the best cable to meet your needs.
Figure 3 - ADL Vantage Data/Power Cable
Each ADL Vantage data/power cable also connects the radio (and in some cases the data
source) to external power via an SAE-type connector. Pacific Crest strongly recommends you
use the ADL Vantage battery (PN A02663), which includes an SAE connector. This is sold both
separately and as part of the ADL Vantage Battery/Charger Kit (PN K01115).
Operating the ADL Vantage
Turning on ADL Vantage
To turn on the ADL Vantage, either attach the programming cable to the radio and to
wall/mains current or attach the data/power cable to the radio and the battery. Then press
the On/Off button in the center of the front panel seen in Figure 4.
Comment [CB2]: Change “GPS
Connector” to “Data Source
Connector”