User's Manual

Juno T41/5

User Manual

6.4 Working with Bluetooth

If your device comes with built-in Bluetooth capability, you can wirelessly

transmit data to and from your device by connecting to available Bluetooth

enabled devices. To find out if you have Bluetooth installed in your device,

tap > Settings > System > System Information > Wireless.

Bluetooth capability is a short-range wireless communication technology

that exchanges information (beam) over a distance of up to 30 feet (10

meters) without requiring a physical connection.

Bluetooth settings: tap > Settings > Bluetooth.

Mode: To enable Bluetooth, select the check box Turn on Bluetooth. If

you want other Bluetooth devices to find your device, also check the Make

this device visible to other devices checkbox.

Devices: Tap Add new device to search for other Bluetooth devices. For

enhanced security, use passcodes.

COM Ports: Available only for Bluetooth-connected devices that support

serial (COM) connections.

Wake Settings: Allow Bluetooth activity to turn the device on. When

this check box is selected, another Bluetooth device can send data and your

device will turn on and reply if necessary, but only if Bluetooth is enabled.

NOTE: It is recommended that your device be configured to automatically

turn off when not in use. Otherwise, another Bluetooth device could turn

on your device, transfer data and if Juno T41/5 does not turn off again,

drain the battery.

Receiving Beams: To allow the device to receive incoming beams, tap

> Settings > Connections > Beam to open the Beam screen. Check the

Receive all incoming beams checkbox and tap OK.

Creating a Bluetooth Partnership: Bluetooth partnerships are required

for connections to some PC’s, printers, and headphones.

Configuring Bluetooth connections vary depending upon how each

Bluetooth device works. Refer to all device documentation.

1. Tap

> Settings > Bluetooth > Mode. Ensure that both

devices have Bluetooth turned on in the Mode area, are visible

and within close range.

2. Tap Devices > Add new device… Wait a few moments while