User's Manual
Table Of Contents
- Safety Information
- About this user guide
- 1 About the Trimble Juno T41 handheld
- 2 Using the phone
- 3 Using the operating system
- The main screens
- Interacting with the handheld, opening applications
- Changing button assignments
- Battery status indicators
- Speaker and network status indicators
- Pre-installed programs
- Changing screen settings
- Using the on-screen keyboard
- Writing or drawing on the screen
- Making a recording
- Sounds and notifications
- Adjusting the display and keypad brightness
- Using the flashlight
- Calibrating the compass
- Installing applications onto the handheld
- Storing data
- Working with files
- Working with Task Manager
- Using Battery Logger
- Using E-mail
- 4 Connecting and syncing to an office computer
- 5 Using the integrated radios
- Choosing a connection method
- Turning on and turning off the integrated radios
- Using the Wireless Manager
- Connecting to a Wi-Fi access point
- Using the Summit utility
- Turning on and turning off the Bluetooth radio from within the Bluetooth appl...
- Making the handheld visible (discoverable) to other Bluetooth devices
- Connecting to a Bluetooth-enabled device
- Accessing a corporate network
- 6 Using the GNSS receiver
- 7 Using the camera
- 8 Using the barcode imager
- 9 Using the UHF RFID scanner
1 About the Trimble Juno T41 handheld
l Turn off the integrated Bluetooth and Wi-Fi radios, and the handheld's cellular modem,
whenever you are not using them. For more information, see Turning on and turning off the
integrated radios, page 63.
Note – Do not disconnect from GNSS if you will be reconnecting within about five minutes. A GNSS
application can take up to 30seconds to reactivate the integrated GNSS receiver, so disconnecting to save
power can cost time.
Selecting the language
The first time the device is turned on or if the firmware is re-loaded, you may need to select the
language you want to use on the device.
IMPORTANT: Carefully choose the correct language because all other languages are removed after
this selection. Contact technical support if you select the wrong language.
1. Because the touchscreen is not yet enabled, use the Up and
Down volume buttons to highlight the language you want
from the list. Press the
Action
button to select it.
2. When you have selected the language, place a checkmark
in the box for
Yes
; press the
+
(Volume up) button to
highlight the box, the press the
Action
button.
3. Press the
-
(Volume down)button twice to highlight the
Next
button, then press the
Action
button.
4. Wait while the device is configured to the selected
language. It will restart when finished.
Note – Only Microsoft applications and messages will be translated into languages other than English. All
other error messages, notifications and other applications may appear in English.
Aligning the screen
When you use the device for the first time, the message Tap the screen to set up your Windows
Mobile-based device appears.
The align screen message displays a series of targets to tap in sequence on the screen. Use the stylus
to tap the targets firmly and accurately. Sometimes you need to repeat the alignment procedure
more than once to provide a satisfactory alignment.
Note – You can align the screen at any time. Tap / Settings / System / Screen, select the General
tab, then tap Align Screen.
Trimble Juno T41 User Guide 21