User's Manual
Table Of Contents
- Safety Information
- About this user guide
- 1 About the Trimble Juno T41 handheld
- 2 Using the phone
- 3 Using the operating system
- The main screens
- Interacting with the handheld, opening applications
- Changing button assignments
- Battery status indicators
- Speaker and network status indicators
- Pre-installed programs
- Changing screen settings
- Using the on-screen keyboard
- Writing or drawing on the screen
- Making a recording
- Sounds and notifications
- Adjusting the display and keypad brightness
- Using the flashlight
- Calibrating the compass
- Installing applications onto the handheld
- Storing data
- Working with files
- Working with Task Manager
- Using Battery Logger
- Using E-mail
- 4 Connecting and syncing to an office computer
- 5 Using the integrated radios
- Choosing a connection method
- Turning on and turning off the integrated radios
- Using the Wireless Manager
- Connecting to a Wi-Fi access point
- Using the Summit utility
- Turning on and turning off the Bluetooth radio from within the Bluetooth appl...
- Making the handheld visible (discoverable) to other Bluetooth devices
- Connecting to a Bluetooth-enabled device
- Accessing a corporate network
- 6 Using the GNSS receiver
- 7 Using the camera
- 8 Using the barcode imager
- 9 Using the UHF RFID scanner
2 Using the phone
Working with WWAN (mobile data service)
After purchasing a data connection plan from your local GSMor CDMA cellular provider, you can
communicate from field to office, send e-mail messages and send text messages.
Note – When browsing the internet using the cellular connection, you must turn off the Wi-Fi (802.11) or the
unit will default to the Wi-Fi to browse.
Before you begin, make sure you have inserted a SIMcard in to the handheld. See Inserting and
removing the SIM card, page 24.
Depending upon the configuration of your handheld, it may have the additional 3G or CDMA
wireless wide area network (WWAN)feature.
Configuring the cellular connection using CellStart
Note – Applications or services that send or receive data over a cellular network may incur additional fees.
Contact your carrier for information about your service plan and fees.
If you are connecting to a GSM network, you will need a SIM card to use cellular services. Make sure
the SIMcard is inserted into the handheld before you turn on and set up the handheld. See
Inserting and removing the SIM card, page 24.
1.
Tap / CellStart. (You may need to tap OK to agree to the terms to open the program.)
Under Available Settings, tap the [+] by your country to expand carriers.
2. Tap the [+] by the carrier you have signed up with and highlight Typical and tap New. (If using
multiple configuration settings, you can tap on the primary setting and tap Default.)
3.
Ensure the phone is turned on. Tap / Settings / Connections / Wireless Manager /
Phone.
4.
Test the settings by tapping / Internet Explorer and then browse to a web page. The
phone will automatically start dialing when you try to open a web page.
5. If the phone will not connect, try other settings before calling the carrier technical support.
6.
You can also manually change modem settings by tapping / Settings / Connections /
Connections.
Note – Once connected, G (GPRS) or E (EDGE - a faster form of GPRS) or H (HSDPA) will automatically appear
in the notification bar depending on the network capabilities in that area; some service providers may only
provide GPRS.
Trimble Juno T41 User Guide 30