User's Manual

2 Using the phone
Configuring the cellular connection on a CDMA network
Trimble Juno T41 products are approved for use on the Verizon network in the USA.
To register the handheld with Verizon:
1. Provide the handheld’s MEID (unique cell radio identifier) to your Verizon account contact. The
MEID is printed on the label on the battery (look for the MEDI/IMEI; the MEID is the first 14
digits).
Alternatively, tap / Settings / Personal / Phone, and select the Info tab. The MEID
number is shown on this screen.
2. When the handheld has been registered on the Verizon network (this can take a couple of days,
check with your Verizon contact), enable and activate CDMA on the unit.
To enable CDMA operation on the handheld:
1.
Tap / Settings / Personal / Cellular Network.
2. From the Network Type dropdown list, select CDMA, then tap OK. The modem resets and
reinitializes in CDMA mode.
3. To activate CDMA, make sure the phone is turned on, and connected to the Verizon network in
an area of good coverage (the signal-strength indicator should show at least two bars).
Tap / Settings / Personal / Cellular Network and then click Activate.
A pop-up message indicates that activation was successful. This may take several minutes.
Note – The activation step requires that the unit is able to connect to the Verizon network during the
activation sequence. Check your location’s Verizon coverage using the Verizon Coverage Locator:
http://www.verizonwireless.com/b2c/support/coverage-locator.
Removing cellular data settings
1.
Tap / CellStart.
2. Tap Refresh to see the current list of configurations
3. Select the configured data setting you want to remove.
4. Tap Remove then tap OK.
When you remove a default configuration, the top setting becomes the new default.
To access the detailed settings for each configuration, tap Menu / Open Connections Applet to
change the modem connections.
Trimble Juno T41 User Guide 31