User's Manual
Table Of Contents
- Safety Information
- About this user guide
- 1 About the Trimble Juno T41 handheld
- 2 Using the phone
- 3 Using the operating system
- The main screens
- Interacting with the handheld, opening applications
- Changing button assignments
- Battery status indicators
- Speaker and network status indicators
- Pre-installed programs
- Changing screen settings
- Using the on-screen keyboard
- Writing or drawing on the screen
- Making a recording
- Sounds and notifications
- Adjusting the display and keypad brightness
- Using the flashlight
- Calibrating the compass
- Installing applications onto the handheld
- Storing data
- Working with files
- Working with Task Manager
- Using Battery Logger
- Using E-mail
- 4 Connecting and syncing to an office computer
- 5 Using the integrated radios
- Choosing a connection method
- Turning on and turning off the integrated radios
- Using the Wireless Manager
- Connecting to a Wi-Fi access point
- Using the Summit utility
- Turning on and turning off the Bluetooth radio from within the Bluetooth appl...
- Making the handheld visible (discoverable) to other Bluetooth devices
- Connecting to a Bluetooth-enabled device
- Accessing a corporate network
- 6 Using the GNSS receiver
- 7 Using the camera
- 8 Using the barcode imager
- 9 Using the UHF RFID scanner
5 īīUsing the integrated radios
5. Do one of the following:
ll To use authentication, select the authentication method from the Authentication list.
l To use data encryption, select an encryption method from the Data Encryption list.
l To automatically use a network key, select the check box for The key is automatically
provided. Otherwise, enter the Network key and the Key index.
6. Tap Next.
7. For increased security, select the Use IEEE 802.1x network access control check box and then
configure additional authentication information.
8. Tap Finish.
Step 2: Connecting to the network or access point
1. Make sure the handheld is not connected to any other device using a USB data cable, as the
handheld prioritizes a USB connection over a Wi-Fi connection.
2. Bring the handheld within range of the network or access point.
When a Wi-Fi netwprk or access point is detected, the icon appears on the title bar.
If the access point icon does not appear, use the Wireless Manager to turn off and then turn
back on the Wi-Fi radio. When the Wi-Fi radio is turned on, any networks or access points
within range are detected and the icon appears.
3. Tap the access point icon on the title bar. A popup message shows the available networks.
4. Select the network you want to connect to and then tap OK.
5. Select The Internet or Work and then tap Connect.
6. If a Network Log On screen appears, enter your user name, password, and domain information
and then tap OK.
7. When the handheld is connected to the network or access point, the Wi-Fi connected icon
appears in the title bar.
8. Start using the program you want to use, for example Internet Explorer.
To disconnect from the network or an access point at any time, turn off the handheldās wireless
radio. To do this, tap title bar, tap the Connectivity icon on the pull-down list, select Wireless
Manager and then tap the Wi-Fi button.
To delete a Wi-Fi connection, tap and hold the connection in the Wireless tab of the Wi-Fi Settings
screen and then select Remove Settings.
Trimble Juno T41 User Guide 65