User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
SETTING UP THE PDL HIGH POWER BASE
Overview of PDL High Power Base (PDL HPB) Radio Modem
Front Panel
Digital Display
TX Indicator
RX Indicator
Channel Change Pushbutton
AMP POWER
Indicator
ON / OFF Indicator
ON / OFF Pushbutton
Figure 1 - PDL High Power Base Front Panel
Buttons
The ON/OFF button is used to turn the PDL HPB station on and
off. Turn the unit on by pressing the ON/OFF button and holding
it until the channel display indicator is lit. Turn off the PDL HPB
by pressing the ON/OFF button until the display goes blank.
There is a one-second turn-off delay in the power button to
prevent inadvertent turn off.