User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
12 Setting Up the PDL High Power Base
The following table shows the default factory settings:
Factory Defaults
Setting PDL Base PDL Rover
Channel mode AutoBase AutoRover
GPS Port Data
Rate
38.4 k Baud 38.4 k Baud
Parity None None
Mode Transparent with
EOT timeout
Transparent with
EOT timeout
EOT value 5 5
Retries 3 3
Link rate 19.2 kbps (raw data) 19.2 kbps (raw data)
Modulation 4-level FSK 4-level FSK
FEC Enabled Enabled
RF Output Power 0.5 - 5 0.5 - 35
Data Scrambling Enabled Enabled
Digisquelch Low High
Break to
command
Off Off
TX ACK timeout 0.10 0.10
CSMA Enabled Enabled
Digidelay 0.0 0.0
Repeater Off Off
Address (local) 0 0
Address (dest) 255 255
Table 1 - PDL Factory Defaults