User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
SETTING UP THE PDL LOW POWER
BASE/REPEATER (PDL LPB)
Overview of PDL LPB Radio Modem
Front Panel
Buttons
The ON/OFF button is used to turn the PDL LPB modem on and
off. Turn the unit on by pressing the ON/OFF button and holding
it until the channel display indicator is lit. Turn off the PDL LPB
by pressing the ON/OFF button until the display goes blank.
There is a one-second turn-off delay in the power button to
prevent inadvertent turn off.
The CHANNEL button is used to display and change the
channel. Press the CHANNEL button momentarily to display the
selected channel. To change the channel press the CHANNEL
button once to light the display, and then again to change the
channel. Release the CHANNEL button when the desired
channel is indicated.
The PDL LPB can be used as a base, rover or repeater. When
used as a base, you have access to AutoBase mode that will aid
in the selection of the channel. Use the CHANNEL button to
select the "b" setting. With "b" selected, the PDL LPB will be
placed in AutoBase mode. This mode selects the channel for
transmission automatically.
When used as a rover or repeater, you may wish to use
AutoRover mode. Press the CHANNEL button to select the “r”