User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
16 Setting Up the PDL Low Power Base/Repeater
setting. With “r” selected, the PDL LPB will be placed in
AutoRover mode. This mode automatically selects the channel
being used by the PDL Base. If you are operating in an area
with more than one PDL Base station active, you should
manually select the channel of operation to assure proper
operation.
Antenna Connector (NMO thread)
Antenna
RX Indicator
TX Indicator
Power On/Off Indicator
Digital Display
Channel Change Pushbutton
On/Off Pushbutton
Data / Power Connector
User Supplied Range Pole
(5/8 - 11 thread)
Figure 4 - PDL Low Power Base