User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
24 Setting Up the PDL Rover
end cap NMO style mount is replaced with a 5/8-11 UNC stud,
allowing the PDL Rover to be used as part of the pole system
with a GPS antenna. See Figure 5.
Range Pole Mount
The bottom end cap is female threaded with 5/8-11 UNC that is
compatible with common range poles. The unit is easily
mounted in the place of a stand-alone antenna and eliminates
the need for an antenna cable.
PDL Rover Setup
Antenna and Antenna Mount
Screw the Antenna on the antenna mount of the PDL Rover. We
recommend inspecting the antenna center push-pin contact to
make sure that it makes good contact with the antenna mount. A
good antenna connection is critical to system performance.
Range Pole Mount
Before connecting any cables, screw the PDL Rover onto the
range pole.