User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
PDL User's Guide 25
Data Cable (from GPS)
Range Pole
External Antenna
Figure 7 - PDL Rover Setup
Connecting the PDL Rover
The PDL Rover is connected to the GPS RTK receiver using the
supplied cable. After connecting the cable, press the ON/OFF
button. Use the CHANNEL button to select the channel of
operation, or select "r" for the AutoRover function. Refer to the
How to Use AutoRover section of this manual for detailed
instructions concerning this feature.