User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
30 Tips and Techniques for Best Performance
Following channel selection, the data received from the GPS will
automatically begin transmitting.
9
Warning: Depending on the number of channels
programmed, channel selection can take from 1 to 16
minutes. We recommend that you set up and turn on
your PDL Base station as soon as possible during
system setup to prevent delays.
Equipment Care
Routine equipment care will prolong the life and reliability of your
PDL family products. Radio communication equipment is
susceptible to damage from shock or environmental extremes.
Never operate the PDL equipment out of the operating
specifications contained in Appendix B.
Error Codes
The PDL performs a variety of power-up and run-time tests to
assure optimal operation. Tests include environmental as well
as electrical measurements designed to avoid damage to the
unit while maintaining adequate operation. In the event of an
error condition, a 3-digit error code is flashed on the display.
Error codes begin with an "E" followed by two numeric digits
indicating the failure mode. Table 2 lists the possible error
conditions.