User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
42 Warranty
If using an antenna with a gain greater than unity please
calculate the RF exposure as per the formula given below:
Distance = √
[gain of antenna x power output x 300]
√ [2 pi x frequency]
Power output in Watts, frequency is in MHz, distance in
meters, and antenna gain is absolute value.
• DO NOT operate the transceiver unless all RF connectors
are secure and any open connectors are properly
terminated.
• DO NOT operate the transceiver with a damaged antenna.
If a damaged antenna comes in contact with the skin, a
minor burn may result.
• DO NOT operate the equipment near electrical blasting caps
or in an explosive atmosphere.
9
Warning: Changes or modifications not expressly
approved by the FCC could void the user’s authority to
operate the equipment.