User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
APPENDIX B - PIN-OUTS AND CONNECTORS
PDL High Power Base
The PDL Base data receptacle is a LEMO PN
HGG.1B.305.CLLP. For a mating plug, we recommend LEMO
PN FGG.1B.305.CLAD.72Z. Refer to Table 2 and Figure 6 for
pin-outs and orientation.
PDL Low Power Base and Rover
The PDL Rover data receptacle is a LEMO PN
HMG.0B.305.CLN. For a mating plug, we recommend LEMO
PN FHG.0B.305.CLAD.52Z. Refer to Table 2 and Figure 7 for
connector pin assignments.
Pin # Description Cable Wire Color
1 Power Red
2 Ground Black
3 RS-232 RX Data Yellow
4 RS-232 Signal Ground White
5 RS-232 TX Data Green
Table 3 - PDL Base and Rover Pin Assignments
Antenna
The PDL High Power Base antenna connector is a BNC female.
For a mating plug, we recommend Amphenol PN 31-320. Use
only high quality 50 Ω impedance cable for the antenna
connection.