User's Manual
Table Of Contents
- NOTICE
- CAUTIONS AND WARNINGS
- INTRODUCTION
- FEATURES AND BENEFITS
- SETTING UP THE PDL HIGH POWER BASE
- SETTING UP THE PDL LOW POWER BASE/REPEATER (PDL
- SETTING UP THE PDL ROVER
- TIPS AND TECHNIQUES FOR BEST PERFORMANCE
- FCC RULES AND REGULATIONS
- SERVICE AND SUPPORT
- WARRANTY
- APPENDIX A - SAFETY INFORMATION
- APPENDIX B - PIN-OUTS AND CONNECTORS
- APPENDIX C - TECHNICAL SPECIFICATIONS
APPENDIX C - TECHNICAL SPECIFICATIONS
General
Serial Port Interface
RS-232 compatible. 1200 to 38400 baud operation with 1 start,
8 data, optional parity, and one stop bit.
Power Supply
9-16 VDC. PDL Rover quiescent/receive power consumption
0.3W. PDL High Power Base quiescent/receive power
consumption is 1.9W. PDL High Power Base in the low/high RF
power setting consumes 13W/125W during transmission. The
PDL Low Power Base quiescent/receive power consumption is
0.9W. The PDL Low Power Base when transmitting consumes
5W/11W. (PDL Base power consumption measured at 12.5
VDC.)
Radio
Frequency Ranges
Contact factory for available frequency ranges. Synthesized
frequency control with approximately 1600 channel capability.
Channel spacing 25/12.5 kHz. 2.5 ppm frequency reference.
Transmitter (PDL Base)
Carrier power variable from 0.5 Watts to 35 Watts nominal for
the High Power Base. Carrier power for the Low Power Base is
factory programmable for the 0.5 Watts to 5 Watts. Output
impedance 50-ohms. Modulation distortion is less than 5%.