GPS Receiver User Manual

Copernicus GPS Receiver 161
TRIMBLE STANDARD INTERFACE PROTOCOL (TSIP) A
The table below lists the individual fields within the Packet 0xC0 and provides query
field descriptions. Any combination of conditions in byte 2 can be specified for
starting up the unit from standby mode. The condition that happens first will trigger
the unit to start up. If byte 2, bit 2 is set to 1, then byte 3 must be greater than 0.
Byte Bit Item Type Value Definition
0 Reset type or
go to standby
mode
BYTE 'H'
‘W’
‘C’
‘S’
‘F’
hot start
warm start
cold start
standby mode
factory reset
1 Store BBRAM
to Flash flag
BYTE 0 Reserved
1 Reserved
2 Store user configuration to
Flash Memory
3 Store user configuration to
Flash memory
4Erase Almanac, ephemeris
and last position from Flash
Memory
5 Erase user configuration
from Flash Memory
6Erase Almanac, ephemeris,
last position and user
configuration from Flash
Memory
2 0 Start-up from
Standby Mode
condition flags
BYTE 0
1
1=start up on serial port A
activity
10
1
1=start up on serial port B
activity
20
1
1=start up after RTC alarm
elapsed
3-4 Number of
seconds to stay
in Standby
mode
UINT32 0 to 2147483647
or
0 to (2
31
- 1)
seconds