User's Guide
Chapter 2: Basic setup and operation
➢ Inserting a SIM card
➢ Installing and removing the optional accessory battery pack
➢ Tethering the stylus
➢ Installing the screen protector
➢ Attaching the pole bracket
➢ Attaching the handstrap
➢ Charging and power modes
➢ Setting up your Ranger 5 / TSC5 for the first time
➢ Using the touchscreen
➢ Using the integrated keyboard
This section tells you how to get started using your Ranger 5 / TSC5 and explains some basic operating system
features. When you start your device for the first time, the Android operating system will take you through
some basic set-up steps; follow the instructions on the screen.
For more details on setting up and using the Android operating system, see
Using the Android 10 operating system or visit the Android 10 website.
Inserting a SIM card
If your Ranger 5 / TSC5 device configuration is equipped with a 4G LTE modem you will require a
data plan and microSIM card from your local cellular service provider to use cellular data. If you are
unsure, check with your mobile operator. See Working with mobile broadband for more
information.
⚠
WARNING - Do not replace the SIM card while outdoors. Water, dust, dirt or debris may collect inside the SIM
card bay causing performance issues.
⚠
CAUTION - The SIM card door can be damaged if handled carelessly or if sharp tools are used to open the
door. Take care not to twist or warp the door when opening or closing it.
1. If the device is on, turn it off; press and hold the Power key, then tap Power off.
2. Using the Philips screwdriver integrated into the stylus pen, loosen the 4 screws to remove
the battery bay cover from the back of the device.
a. NOTE - If the accessory battery is installed, remove it to access the SIM card door.
Trimble Ranger 5 Data Collector / Trimble TSC5 Controller User Guide |26