User's Guide
U.S.
FCC ID: S9E-121900
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions may cause harmful interference to radio communication. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and the receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate
this equipment under Federal Communications Commission rules.
The radios in this device have been designed and manufactured to not exceed stipulated emission limits for exposure to radio frequency
(RF) energy as required by the Federal Communications Commission of the U.S. Government 47 C.F.R. § 2.1091 and 2.1093.
This equipment should be installed and operated with minimum distance 1 cm between the radiator & your body. This device and its antenna(s) must not be
co-located or operating in conjunction with any other antenna or transmitter. The County Code Selection feature is disabled for products marketed in the US/Canada.
Operation on the 5.15-5.25GHz frequency band is restricted to indoor use only. The FCC requires indoor use for the
5.15-5.25GHz band to reduce the potential for harmful interference to co-channel Mobile Satellite Systems. Therefore, it will only transmit
on the 5.25-5.35 GHz, 5.47-5.725 GHz and 5.725 –5.850 GHz band when associated with an access point (AP).
CE
a. Caution:
• Risk of explosion if battery replaced by an incorrect type.
• Dispose of used batteries according to the instructions.
b. Make sure the temperature for the adapter while charging is within 0-45 ˚C (32-113˚F).
Limited Warranty Terms and Conditions
Product Limited Warranty
Subject to the terms and conditions set forth herein, Trimble Inc. (“Trimble”) warrants that for a period of (2) years from date
of purchase this Trimble product (the “Product”) will substantially conform to Trimble's publicly available specifications for the
Product and that the hardware and any storage media components of the Product will be substantially free from defects in
materials and workmanship.
Product Software
Product software, whether built into hardware circuitry as firmware, provided as a standalone computer software product,
embedded in flash memory, or stored on magnetic or other media, is licensed solely for use with or as an integral part of the
Product and is not sold. The terms of the end user license agreement, as included below, govern the use of the Product
Software, including any differing limited warranty terms, exclusions and limitations, which shall control over the terms and
conditions set forth in the limited Product warranty.
Warranty Remedies
If the Trimble Product fails during the warranty period for reasons covered by this limited warranty and you notify Trimble of
such failure during the warranty period, Trimble will repair OR replace the nonconforming Product with new, equivalent to
new, or reconditioned parts or Product, OR refund the Product purchase price paid by you, at Trimble’s option, upon your
Trimble Ranger 5 Data Collector / Trimble TSC5 Controller User Guide |6