User's Guide
across multiple users, field roles and job requirements.
For more information about the EMPOWER platform, and the selection of EMPOWER enabled
modules that are compatible with your device, contact your local reseller, or go to
empower.trimble.com.
The functionality of EMPOWER modules is unlocked through applications and utilities developed
specifically for each module. For more information about using Trimble EMPOWER modules, refer to
the module documentation available here: www.trimble.com/empowermodules.
Module functionality can also be directly integrated into field software by developers with access to
the Trimble EMPOWER Developer Program using system and module SDKs and APIs. Module
Developer Kits are also available to quickly prototype custom modules.
For more information on the developer resources and tools available for the Ranger 5 / TSC5,
contact your local reseller, or go to empower.trimble.com/developer.
Installing & removing EMPOWER modules on the device
To attach or remove a module to your Ranger 5 / TSC5, follow the steps below:
1. NOTE – Before you install or remove a module from the device, make sure the device is
powered off or in Sleep state.
a. For more information, see Charging and power modes.
2. Turn the device over.
3. To attach the module:
a. Hook the EMPOWER module onto the device, ensuring that the slots on the top of
the device line up with those on the EMPOWER module.
b. Tighten the 2 captive screws at the bottom of the EMPOWER module using a Phillips
#1 screwdriver. The stylus included in the Ranger 5 / TSC5 packout has an integrated
screwdriver which may be used. Do not overtighten the screws.
c. Press the Power key to start or wake-up your Ranger 5 / TSC5, then follow the
instructions in the next section to install drivers and software for your module if
Trimble Ranger 5 Data Collector / Trimble TSC5 Controller User Guide |69