User's Guide




To set up your workspace with the desktop hub:
1. Plug the AC end of the desktop hub power cord into an electrical outlet or power strip, and
plug the other end into the power port on the desktop hub.
2. If you want to use a wired network connection, connect a network cable to the Ethernet port
on the desktop hub.
3. Connect your computer peripherals to the USB ports on the desktop hub.
4. Connect a cable from your monitor to the HDMI Port on the desktop hub. If your monitor
cable doesn’t have a HDMI connector, you’ll need to buy another cable or an adapter.
5. Connect the Ranger 5 / TSC5 to the desktop hub using the USB-C cable included with the
Ranger 5 / TSC5.
Using the accessory battery and charger
➢ Using the accessory battery
➢ Charging and power modes
Chapter 7: Using the camera
➢ Taking photos and videos
➢ Changing camera settings
➢ Viewing photos and videos
The Ranger 5 / TSC5 is fitted with one rear facing 13MP autofocus camera with LED flash. The
camera is accessible by the camera application. This section describes how to make use of the Ranger 5 /
TSC5 device’s onboard camera.

NOTE – The device may be shipped with a protective film covering the rear camera and flash
windows. Remove the film before first use to ensure proper focus and exposure of your photos and
videos
Trimble Ranger 5 Data Collector / Trimble TSC5 Controller User Guide |72