User Manual
Table Of Contents
- 5700/5800 GPS Receiver
- Contents
- About This Manual
- 5700 GPS receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- 5800 GPS receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- 5700 & 5800 Appendixes
- NMEA-0183 Output
- Troubleshooting
- Index
16 Specifications
168 5800 GPS Receiver User Guide
55800 Reference
16.4Technical Specifications
Table 16.3 lists technical specifications for the 5800 receiver.
Table 16.3 Technical specifications
Feature Specification
Tracking 24 channels L1 C/A code, L1/L2 full cycle carrier
Fully operational during P-code encryption
WAAS satellite tracking
Signal processing Maxwell architecture
Very low-noise C/A code processing
Multipath suppression
Start-up Cold start: < 60 seconds from power on
Warm start: < 30 seconds with recent ephemeris
Initialization Automatic while moving or static
Minimum
initialization time
10 sec + 0.5 × baseline length (km)
Communications Two RS-232 serial ports (Port 1, Port 2,)
Port 1: Baud Rates up to 38,400 bps
Port 2: Baud Rates up to 115,200 bps
RTS/CTS flow control negotiation supported on Port 2
only
Bluetooth communications with Trimble ACU or TSCe
with Bluecap module
Configuration Via user-definable application files or GPS
Configurator
Output formats NMEA-0183: GGA; GST; GSV; PTNL,GGK;
PTNL,GGK_SYNC; PTNL,PJK; PTNL,PJT;
PTNL,VGK; VHD; VTG; ZDA
GSOF (Trimble Binary Streamed Output)
RT17