User Manual
Table Of Contents
- 5700/5800 GPS Receiver
- Contents
- About This Manual
- 5700 GPS receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- 5800 GPS receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- 5700 & 5800 Appendixes
- NMEA-0183 Output
- Troubleshooting
- Index
2 Setting up the Receiver
32 5700/5800 GPS Receiver User Guide
5700 Operation
Mounting the 5700 receiver
To mount the 5700 receiver on the pole:
1. Attach the receiver bracket to the pole:
a. Place the bracket against the pole, approximately 0.5 m
from the ground.
Note – If you are using a 1" diameter pole, flip the black
insert around inside the bracket as shown in Figure 2.8.
Figure 2.8 shows details of the bracket insert.
Figure 2.8 Receiver bracket insert
b. Close the gates of the bracket around the pole.
c. Seat the base of the clip lock in the opposite gate.
d. Lock the clip lock.
Bracket insert Bracket
1
1
/
4
" pole
1" pole