User Manual

2 Setting up the Receiver
34 5700/5800 GPS Receiver User Guide
5700 Operation
Mounting the TSC1/TSCe data collector
To mount the TSC1/TSCe data collector on the pole:
1. Mount the data collector bracket on the pole:
a. Place the bracket against the pole at a comfortable height.
b. Rotate the clamping screw on the bracket pole until tight.
c. Place the data collector into the cradle assembly and
tighten the clamping mechanism.
d. Any cables running down the pole should be run through
the machined groove on the inside of the data collector
bracket.
e. Position the data collector in the preferred position for
operation by pressing the spring-loaded release button on
the cradle, pulling the assembly outward, and rotating the
cradle assembly to the desired angle. Reseat the cradle in
the proper position by lining up the alignment pins and
pushing inward until the release button locks.
2. Connect one end of the 2 ft 0-shell to 0-shell Lemo cable to the
TSC1/TSCe data collector.
3. Connect the other end of the Lemo cable to Port 1 on the 5700
receiver.
4. Place the hand grip below the data collector bracket (or above
it, depending on the position of the bracket), with the cables
running through the grip.
5. Secure any loose cables, using the velcro cable ties.
Figure 2.10 shows the pole-mounted setup.