User Manual
Table Of Contents
- 5700/5800 GPS Receiver
- Contents
- About This Manual
- 5700 GPS receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Transferring Data
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- Event Marker Input and 1PPS Output
- 5800 GPS receiver
- Overview
- Setting up the Receiver
- General Operation
- Configuration
- Software Utilities
- Specifications
- Default Settings
- Cables and Connectors
- 5700 & 5800 Appendixes
- NMEA-0183 Output
- Troubleshooting
- Index
5700/5800 GPS Receiver User Guide 73
Transferring Data 5
5700 Operation
5.3 Transferring Data
Transfer the data files to the computer using the Trimble Data Transfer
utility. You can run this utility as a standalone program or from within
Trimble Geomatics Office. For more information about the transfer
process, refer to the Data Transfer Help.
Note – When you connect to a 5700 receiver in the Data Transfer
utility, you must use a GPS Receiver (5000 Series) device definition. If
you use a GPS Receiver (4000 Series) device definition, the Data
Transfer utility will be unable to establish communication with the
5700 receiver.
When transfer is complete, the Data Transfer utility automatically
converts the file to the DAT format. If you are using Data Transfer
from within Trimble Geomatics Office, the Check-in dialog appears.
For more information, refer to the Trimble Geomatics Office User
Guide.
Note – A file in DAT format is approximately six times the size of the
corresponding file in the 5700 receiver’s internal format. Before
transferring files, make sure that there is enough space on your
computer.