User's Manual

5 Setting up the Receiver
54 SPSx50 Modular GPS Receiver User Guide
The receiver needs to be accessed only to turn it on at the start of each
measurement session. It may be more convenient if the SPSx50 is placed in a
location where the vehicle operator can see the keypad and display, to monitor
receiver status and to configure settings as required. Most receiver capability
can be controlled using the SCS900 controller software.
4. Attach the suction cup to either the front windscreen, dashboard, or other
convenient location in the vehicle making sure that it does not obstruct the
drivers view.
5. Attach the RAM extension arm to the suction cup, and the controller bracket to
the RAM extension arm.
6. Lock the controller into the controller bracket, and adjust the bracket until the
controller is in the most convenient location. Make sure that the controller does
not restrict visibility through the front windscreen during vehicle use.
7. Lock the brackets so that the controller is held securely. If required, connect
either the GPS receiver or the controller to in vehicle power supplies as needed.
Figure 5.5
S antenna in a magmount on vehicle roof
n
troller in suction cup mount in vehicle.
b
/Nick providing.
19 Dec. Needing mockup/instructions from product staff