User's Manual

SPSx50 Modular GPS Receiver User Guide 55
Setting up the Receiver 5
Setting up the rover receiver on a rod
For rod-based operation, mount the SPSx50 Modular
GPS receiver or SPS770 Modular GPS receiver using the
two rod brackets as follows:
1. Mount the two rod brackets on the rod.
2. Tighten the uppermost of the two making sure
that it is at a convienent height for the receiver.
3. Place the receiver into the slot in the rod bracket,
and secure it with the tripod clip.
4. Lower the lower of the two rod brackets over the
second tripod clip on the receiver, and tighten
onto the rod. The receiver is held in place
between the two brackets.
5. Mount the controller into the controller bracket
as shown <?>.
6. Attach the GPS antenna to the top of the rod
using the 5/8 thread.
7. Connect the receiver to the GPS antenna using
the antenna cable.
For rod-based operation, mount the SPSx80 Smart GPS
antenna as follows:
1. Mount the receiver to the top of the rod using the 5/8-11 thread in the base of
the SPSx80.
2. Mount the controller into the controller bracket as shown <?>.
3. The SPSx80 and controller will communicate through Bluetooth wireless
technology. However, if a cable is required, connect the cable between the
controller and receiver (see Figure 5.6 through Figure 5.8). <<I NEED TO
KNOW WHICH CABLES SO VANESSA CAN ILLUSTRATE CORRECTLY>>
19 Dec. With Vanessa.
SPSx50 Rover ISO.jpg