User's Manual

SPSx50 Modular GPS Receiver User Guide 61
Setting up the Receiver 5
4. Use the four Posi screws to secure the plate to the receiver. (Secure two screws
at each end.) The black plate is now attached to the bottom of the SPSx50 GPS
receiver.
5. Replace the rubber endcaps.
6. Invert the SPSx50 receiver again. This returns the receiver to its normal
orientation.
7. Set aside the SPSx50 receiver.
8. Invert the SPS550H receiver and remove the rubber endcaps.
9. Position the black cradle on the SPS550H GPS receiver. (The black cradle is part
of the mounting frame.)
10. Use the four Posi screws to attach the black cradle to the receiver. The black
cradle is now attached to the bottom of the SPS550H.