User's Manual

6 Configuring the SPSx50 Modular GPS Receiver Using the Keypad and Display
70 SPSx50 Modular GPS Receiver User Guide
Setting the reference latitude, longitude, and height of the base station
In the Base Latitude screen:
1. The base was set up with a “Here” position, so press
Enter.
2. The Base Longitude screen is used to change the reference longitude of the base
station. The base was set up with a “Here” position, so press
Enter.
3. The Point Height screen is used to change the reference height of the base
station. The base was set up with a “Here” position, so press
Enter.
4. Use the Antenna Type screen to select the type of antenna used with the receiver.
Press
Right. When the antenna name begins to flash, the receiver is in Edit
mode and you can select an antenna.
5. Press
Down to scroll through the antenna models.
6. Once the correct antenna name is displayed, press
Enter to accept the change.
7. Press
Enter again. The Measured To screen appears. See next.
Measuring and changing the antenna height
In the Measured To screen:
1. Press
Right. When the antenna measurement method begins to flash, the
receiver is in Edit mode and you can select an antenna measurement method.
2. Press
Down to scroll through the measurement methods. Once the correct
measurement method appears, press
Enter to accept the change.
3. Press
Enter.
4. Use the Antenna Height screen to change the height of the antenna. Press
Enter.
When the first character of the antenna height begins to flash, the receiver is in
Edit mode and you can change the antenna height.
5. Press
Up or Down to change the value of the character.
6. Press
Right to move the cursor to the next character.
7. Repeat Step 5 through Step 6 to enter the height of the antenna.
8. Press
Enter to accept the change.
9. Press
Enter again. The Output screen appears. See next.
Outputting corrections
In the Output screen :
1. Press
Right to enter Edit mode for the port.
2. Press
Up or Down to change which port will be used to output corrections.
3. Press
Enter to accept the change.
4. Press
Down to move the cursor to the Format field.