User's Manual

SPSx50 Modular GPS Receiver User Guide 71
Configuring the SPSx50 Modular GPS Receiver Using the Keypad and Display 6
5. Press Right to enter Edit mode for the format.
6. Press
Up or Down to change which correction message will be output on the
port.
7. Press
Enter to accept the change.
8. Press
Enter again.
9. Use the NMEA screen to set up NMEA outputs from the receiver. Press
Enter to
accept the default of no NMEA messages.
10. Use the GSOF screen to set up GSOF outputs from the receiver. Press
Enter to
accept the default of no GSOF messages.
11. Use the RT17 screen to set up RT17 outputs from the receiver. Press
Enter to
accept the default of no RT17 messages. The Home screen appears and the base
setup is complete.
Configuring the SPSx50 as a rover receiver
You can use the Trimble SCS900 Site Controller software or the receiver keypad to set
up the SPSx50 base receiver.
The receiver is configured step by step to ensure that all appropriate settings are
configured. To move between steps in the configuration process, press
Enter.
Configuring the receiver
1. In the Home screen, press Enter. Use the Operation Mode screen to configure
system settings, mode settings, or to view the SV (satellite) status. Mode Settings
is the default setting.
2. Press
Enter. Use the Mode screen to select whether the receiver will operate as a
base or rover.
3. Press
Right. When the mode begins to flash, the receiver is in Edit mode and
you can change this setting.
4. Press
Down to change to Rover.
5. Press
Enter to accept the change.
6. Press
Enter again to move to the next screen. <<screen name? provides a neat
link>>See next.
Changing the elevation mask and RTK mode
1. Press
Right . When the value for the current elevation mask begins to flash, the
receiver is in Edit mode and you can change the setting.
2. Press
Down to change the elevation mask to the required value.