User's Manual

SPSx50 Modular GPS Receiver User Guide 73
Configuring the SPSx50 Modular GPS Receiver Using the Keypad and Display 6
To access these receiver settings:
1. In the Home screen, press
Enter. Use the Operation Mode screen to configure
system settings or mode settings, and to view the SV (satellite) status. Mode
Settings is the default setting.
2. Press
Right. When the operation mode begins to flash, the receiver is in Edit
mode and you can change this setting.
3. Press
Down to change to System Setup.
4. Press
Enter to accept the change.
5. Press
Enter again.
6. Use the Display Language screen, if necessary, to change the language. Choose
English, French, German, Italian, or Spanish. Press
Enter to accept the change.
7. Press
Enter again. Use the Display and Input Units screen, if necessary, to change
the units to Meters or Feet.
8. Press
Enter to accept the change.
9. Press
Enter again. Use the Port Settings screen, if necessary, to change the port.
10. Press
Enter to accept the change.
11. Press
Enter again. Use the Screen Pwr Savr screen to choose whether On, Off, or
Auto. If you use the Auto setting, 60 seconds. This setting turns the screen off
after a specified period of inactivity. The Power LED remain lit so you can tell if
the receiver is on or off. If an error message appears, the screen comes back on.
Press
Enter to accept the change and then press Enter again to move to the next
screen.
12. The Autobase warning screen appears. <<when I used the x50, this screen didn’t
appear? Dianne> See Chapter 7, Autobase Feature.
13. Press
Enter to accept the change.
14. Press
Enter again. When the Home screen appears, the system setup is
complete.