User's Manual

802.11g Wireless LAN+BT SiP combo Module V2.2
All rights are reserved by USI. No part of this technical document can be reproduced in any form without permission of USI.
Preliminary release for evaluation, Subject to be changed without Notice
Change Sheet
Rev. Date Description of change Approval & Date
Page Par Change(s)
1.0 10/1/04 All All Draft version for Review
2.0 04/11/05 6,15,
17,22
,23,
25~2
7
1.
Executive summary for target available
date from “the middle of 1Q 2005”
to
“ the end of 2Q”
2. Output power for 11g is 13 +/- 1dBm
3. Update the mech. Drawing .
4.
Modify the function description for
Marvell Transceiver from ”8010”
to
“8015”
5.
Correct the Pin Definition for xxx_B is
for “active_high”
6.
add description for Pin 28;36;43;58 ;
which reserved for BT’
s PCM interface ,
make it no confuse in customer reading.
2.1 04/18/05 25
1. correct the pin definition for Pin24 from
“Control si
gnal to enable engineer testing
mode “ to “Output signal to indicate 16 bit IO
operation. This signal is connected to ground at module
side to indicate 16 bit IO..”
then Type is for GND to
indicate the module under the mode for 16bit IO.
2.2 04/28/05 24 1. Pin A10 pin definition change from “
the pin
is open to “
This address range is mainly used
for accessing the CIS in Memory Mode. Signal
HA0 is not used in word access mode.”
, Type
change from “ No connection” to “
Input ,
PD,5VT”