Install Guide

Install Overview
 The Trimble Gateway device includes internal Cellular, WiFi, and GPS antennas.
– Mount the module in or on the dash with a clear view of the sky unobstructed by metals, with
the top pointing to the sky.
– Attach the module securely using the screws provided, strong two-sided tape, or plastic ties.
– Be sure the module is clear of driver activities and potential environmental hazards.
 Connect to the vehicle Power and Engine Data using the cables and adapters noted
in the following pages.
– The main cable includes an RP1226 connector for most late-model vehicles.
– Adapters are available to connect at the diagnostic port if needed, as well as a 2-pin cable for in-
dash installations.
 The optional white Ignition lead is available if needed, but most vehicles will boot
normally using the J1939 Engine Data signal.
 The display will power from the three-pin Power/Ignition/Ground connector, while
all Display communications take place over WiFi.