User's Manual

TI RF Module Integration Manual

This module will be built in only in Trimble

products by Trimble itself. Trimble makes sure

that the maximum voltage is 3.8V.

The design is based on the CC2520 from Texas Instruments.

• P1: Vdd supply voltage 1.8 - 3.8V

• P2: GND

• P3: SO SPI Interface Serial Out

• P4: SI SPI Interface Serial In

• P5: SPI_CLK SPI Interface Serial clock 8MHz max

• P6: CS_N SPI Interface Chip select active low

• P7: External Reset pin active low

• P8: Vreg_EN when High, digital voltage regulator is active

• P9: GPIO0 general purpose digital I/O

• P10: GPIO1 general purpose digital I/O

Mounting instruction:

The module could be mounted and connected with a plug connector or could be mounted on a

plastic holder and connected with cable (P1-P10).

Maximum Voltage: 3,8V

Connect the SPI Port to a microcontroller and use the instruction of Texas Instruments to start

running the module.

Pad

Function

P1 Vdd

P2 GND

P3 SPI_IN

P4 SPI_OUT

P5 SPI_CLK

P6 CS_N

P7 Reset

P8 Vreg_EN

P9 GPIO0

P10 GPIO1

PAGE 1
TI RF Module Integration Manual This module will be built in only in Trimble products by Trimble itself. Trimble makes sure that the maximum voltage is 3.8V. Pad P1 P2 P3 P4 P5 P6 P7 P8 P9 P10 Function Vdd GND SPI_IN SPI_OUT SPI_CLK CS_N Reset Vreg_EN GPIO0 GPIO1 The design is based on the CC2520 from Texas Instruments. • • • • • • • • • • P1: Vdd supply voltage 1.8 - 3.
PAGE 2
ID´s: FCC: PWR-TK14RF IC: 4131A-TK14RF Units with this module have to mark on the label with: Contains FCC ID: PWR-TK14RF Contains IC: 4131A-TK14RF Statements: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules.