User's Manual

TI RF AMP Module Integration Manual

This module will be built in only in Trimble products by Trimble itself. Trimble makes sure that the

maximum voltage is 3.8V.

The design is based on the CC2520 from Texas Instruments.

• VDD: supply voltage 1.8 - 3.8V

• GND

• SPI_OUT: SPI Interface Serial Out

• SPI_IN: SPI Interface Serial In

• SPI_CLK: SPI Interface Serial clock 8MHz max

• CS_N: SPI Interface Chip select active low

• RESET_N: External Reset pin active low

• VREG_EN: when High, digital voltage regulator is active

• GPIO0: general purpose digital I/O

• GPIO1: general purpose digital I/O

Mounting instruction:

The module could be mounted and connected like a SMD_component.

Maximum Voltage: 3,8V

Connect the SPI Port to a microcontroller and use the instruction of Texas Instruments to start

running the module.

ID´s:

FCC: PWR-TK42RF

IC: 4131A-TK42RF

Units with this module have to mark on the label with:

Contains FCC ID: PWR-TK42RF

Contains IC: 4131A-TK42RF

PAGE 1
TI RF AMP Module Integration Manual This module will be built in only in Trimble products by Trimble itself. Trimble makes sure that the maximum voltage is 3.8V. The design is based on the CC2520 from Texas Instruments. • • • • • • • • • • VDD: supply voltage 1.8 - 3.
PAGE 2
Statements: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This device complies with Industry Canada licence-exempt RSS standard(s).