Installation Manual

Date: 2018.7.16
Doc No: PS-M-0434
Ver. D
Page - 6 - of 17
• For cUL listed products only: Fire class rating: C
• The fire rating of the module is valid only when mounted in the manner specified in the mechanical mounting
instructions.
• The module is considered to be in compliance with UL1703 only when the module is mounted in the manner
specified by the mounting instructions.
• A module with exposed conductive parts is considered to be in compliance with UL1703 only when it is
electrically grounded in accordance with the instructions and the requirements of the National Electrical
Code.
• Any module without a frame (laminate) shall not be considered to comply with the requirements of UL1703
unless the module is mounted with hardware that has been tested and evaluated with the module under
this standard or by a field Inspection certifying that the installed module complies with the requirements of
UL1703.
• Modules equipped with PV wiring connectors that comply with the Standard for Connectors for Use in
Photovoltaic Systems, UL 6703, shall have the specific allowable mating connector manufacturer(s) and
model number(s) listed as below:
Female type
Allowable male
type to mate
Connector
manufacturer
Contact
information
and/or website
of the PV
connector
manufacturer
Trade mark
identification
Rated Voltage
PVMC4PLS-XX
PVMC4PLS-XX
Staubli
Electrical
Connectors AG
http://ec.staubli.
com/
MC
1000V or 1500V
PV-KBT4
PV-KST4
Staubli
Electrical
Connectors AG
http://ec.staubli.
com/
MC
1000V
PV-KBT4-EVO2
PV-KST4-EVO2
Staubli
Electrical
Connectors AG
http://ec.staubli.
com/
MC
1000V or 1500V
QC4.10-ab
QC4.10-ab
QC Solar
(Suzhou) Corp
http://www.quic
k-contact.com/
QC
1000V
QC4.10-cd
QC4.10-cd
QC Solar
(Suzhou) Corp
http://www.quic
k-contact.com/
QC
1000V or 1500V
Helios H4
Assembled
Helios H4
Assembled
Amphenol
Industrial
Operations
http://www.amp
henol-industrial
.com
AMPHENOL
1000V
UTXCFd4Ag
(“d”=A or B;
“g”=I, C or M)
UTXCMd4Ag
(“d”=A or B;
“g”=I, C or M)
Amphenol
Technology
(Shenzhen) Co
Ltd
http://www.amp
henol-industrial
.com
UTX
1000V or 1500V
TS4
TS4
Changzhou Trin
a Solar Energy
Co., Ltd
www.trinasolar.
com
TS4
1000V or 1500V
• At time of receipt, verify that the product delivered is in fact the product ordered. The product name,
subname, and serial number of each laminate are clearly marked on the outside of each packing box.
• Leave the product in its original packing box until you are ready to install.
• Store packing boxes in a clean, dry area with relative humidity below 85% and storage temperatures
between -20°C and 50°C.
• Do NOT stack more than the maximum amount of allowable pallets on top of each other.
• At the installation site, take care to keep modules and particular their electrical contacts clean and dry before
installation. If connector cables are left in damp conditions then the contacts may corrode. Any module with
corroded contacts should not be used.
3. UNPACKING AND STORAGE