Installation Manual
Table Of Contents
- 1. DISCLAIMER OF LIABILITY .............................................................................................................. - 3 -
- 5.1 CLIMATE CONDITIONS
- 5.2 SITE SELECTION
- 6.1 MOUNTING METHODS
- B. Mounting with Clamps
- C. Mounting with Single-axis Tracking System
- 6.2 GROUNDING
- 6.3 MODULE WIRING
- 7.1 FUSING
- 7.2 INVERTER SELETION AND COMPATIBILITY
Date: 2018.7.16
Doc No: PS-M-0434
Ver. D
Page - 9 - of 17
Figure 1. PV module installed with Bolt fitting method
1) Installing Hole (Φ9x12 will be replaced step by step by Φ9x14 from Aug 2017 to Q2 2018)
2) Aluminum Frame 3) M8 Stainless Bolt
4
) Flat Stainless Washer 5) Spring Stainless Washer
6) HEX Stainless Nut
B. Mounting with Clamps
• Trina Solar has tested its modules with a number of clamps from different manufacturers and
recommends the use of clamps which have an EPDM or similar insulating washer, fixing bolt of at least
M6.
• The clamp must overlap the module frame by at least 7mm (0.28in) but no more than 10mm (0.39in).
• Use at minimum 4 clamps to fix modules on the mounting rails.
DRAIN HOLE
1