User manual

TMCM-1180 and PD86-1180 TMCL Firmware V4.42 Manual (Rev. 1.08 / 2012-NOV-20) 17
www.trinamic.com
5.4.6.4 Further configuration of interrupts
Some interrupts need further configuration (e.g. the timer interval of a timer interrupt). This can be done
using SGP commands with parameter bank 3 (SGP <type>, 3, <value>). Please refer to the SGP command
(paragraph 5.7.9) for further information about that.
5.4.6.5 Using interrupts in TMCL™
To use an interrupt the following things have to be done:
 Define an interrupt handling routine using the VECT command.
 If necessary, configure the interrupt using an SGP <type>, 3, <value> command.
 Enable the interrupt using an EI <interrupt> command.
 Globally enable interrupts using an EI 255 command.
 An interrupt handling routine must always end with a RETI command
The following example shows the use of a timer interrupt:
VECT 0, Timer0Irq //define the interrupt vector
SGP 0, 3, 1000 //configure the interrupt: set its period to 1000ms
EI 0 //enable this interrupt
EI 255 //globally switch on interrupt processing
//Main program: toggles output 3, using a WAIT command for the delay
Loop:
SIO 3, 2, 1
WAIT TICKS, 0, 50
SIO 3, 2, 0
WAIT TICKS, 0, 50
JA Loop
//Here is the interrupt handling routine
Timer0Irq:
GIO 0, 2 //check if OUT0 is high
JC NZ, Out0Off //jump if not
SIO 0, 2, 1 //switch OUT0 high
RETI //end of interrupt
Out0Off:
SIO 0, 2, 0 //switch OUT0 low
RETI //end of interrupt
In the above example, the interrupt numbers are used directly. To make the programme better readable
please use the provided include file Interrupts.inc. This file defines symbolic constants for all interrupt
numbers which can be used in all interrupt commands. The beginning of the above programme then looks
like the following:
#include Interrupts.inc
VECT TI_TIMER0, Timer0Irq
SGP TI_TIMER0, 3, 1000
EI TI_TIMER0
EI TI_GLOBAL
Please also take a look at the other example programs.