User Manual

TMCM-6212 CANopen
®
Firmware Manual • Firmware Version V3.22 | Document Revision V1.05 • 2019-FEB-13
9 / 131
1.2 Abbreviations used in this Manual
Abbreviations
CAN Controller area network
CHGND chassis ground / earth ground
COB Communication object
FSA Finite state automaton
FSM Finite state machine
NMT Network management
ID Identifier
LSB Least significant bit
MSB Most significant bit
PDO Process data object
PDS Power drive system
RPDO Receive process data object
SDO Service data object
TPDO Transmit process data object
EMCY Emergency object
rw Read and write
ro Read only
hm Homing mode
pp Profile position mode
pv Profile velocity mode
vm Velocity mode
Table 1: Abbreviations used in this Manual
1.3 Firmware Update
The software running on the microprocessor consists of two parts, a boot loader and the CANopen
firmware itself. Whereas the boot loader is installed during production and testing at TRINAMIC and
remains untouched throughout the whole lifetime, the CANopen firmware can easily be updated by the
user. The new firmware can be loaded into the module via the firmware update function of the TMCL-IDE,
using the USB interface of the module.
1.4 Trinamic’s unique Features — easy to use with CANopen®
1.4.1 StallGuard2™
StallGuard2 ™ is a high-precision sensorless load measurement using the back EMF of the coils. It can be
used for stall detection as well as other uses at loads below those which stall the motor. The StallGuard2 ™
measurement value changes linearly over a wide range of load, velocity, and current settings. At maximum
©2019 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com