User's Manual
Table Of Contents
- 1. General introduction
- 2. Technical parameters
- 3. Mechanical characteristics
- 4. Operation mode
- 5. Protocol mode
- 6.Function description
- 7.Quick start
- 8. User instruction set
- 8.1 HEX read command description
- 8.2 HEX Parameter description
- 8.3. HEX command data communication format
- 8.4 AT Command
- 8.4.1 AT+DEV
- 8.4.2 AT+EXIT
- 8.4.3 AT+MODE
- 8.4.4 AT+RMODE
- 8.4.5 AT+NWK
- 8.4.6 AT+PANID
- 8.4.7 AT+KEY
- 8.4.8 AT+SHORT_ADDR
- 8.4.9 AT+MAC_ADDR
- 8.4.10 AT+COOR_SHORT_ADDR
- 8.4.11 AT+COOR_MAC_ADDR
- 8.4.12 AT+GET_SHORT_ADDR
- 8.4.13 AT+GROUP
- 8.4.14 AT+CH
- 8.4.15 AT+TXPOWER
- 8.4.16 AT+UART
- 8.4.17 AT+SLEEP
- 8.4.18 AT+DATA_TIME
- 8.4.19 AT+SOFT_ID
- 8.4.20 AT+RESET
- 8.4.21 AT+RESTORE
- 8.3.22 AT+GPIO_PUT
- 8.4.23 AT+RGPIO_PUT
- 8.4.24 AT+GPIO_LEVEL
- 8.4.25 AT+RGPIO_LEVEL
- 8.4.26 AT+PWM
- 8.4.27 AT+RPWM
- 8.4.28 AT+ADC
- 9.User instruction
- 10. Hardware design
- 11. FAQ
- 12. Production guidance
- 13.Antenna information
- 14. Product packaging figure
D2106-THGN01_User Manual
9
7.Quick start
The ZigBee ad hoc network module is easy to use. In order to allow users to be quickly familiar with modules,this
section will guide users to achieve configuration and communication in various modes via a simple configuration. The
working mode is mode 3 (protocol mode).
The user can pull down the P1.6 pin and conduct the HEX instruction set. In order to facilitate observation of the host
computer , the experiment will use HEX command format, AT command users do not test in this test. (AT command
cannot be used for the configuration of host computer. )
In addition, the user can use the external microcontroller (MCU) instead of test board directly to connect with module for
UART command communication to achieve secondary development.
7.1 Network construction and communication
No
Notes
1
【
Construct network
】：
①
.Connect Zigbee ad hoc module via USB to UART converter.
②
.Open host computer software “ Zigbee_Setting_V1.1 ” , select Com port and set baud rate as
115200(default), then open port;
③
.Click read parameter to read corresponding module parameter.