User's Manual

D2106-THGN01_User Manual
15
【
Multicast
】：
Broadcast
：
broadcast only conduct Mode 1, the entire network conduct broadcast mode
experiment, other modes test by themselves ）
Data function transmission needs to reflect its own characteristics in the case of multi-node network, the users can test
by themselves！
8. User instruction set
In order to facilitate user use, D2106-THGN01 ZigBee module uses two instruction formats, namely AT instruction
format and HEX instruction format. The format mode is controlled by default P1_6.
When P1_6 = 0, the module enters HEX instruction mode. In this mode, input +++, enter the temporary AT
instruction mode. AT command can be used to configure, input AT + EXIT exit temporary AT command.
When P1_6 = 1, the module enters AT instruction mode. Line break endings cannot be used in AT instructions.
Remarks：
1 Serial data format error message
HEX instruction mode ： F7 FF
AT instruction mode ： +ERROR<CR><LF>
2 Coordinator device network establishment will prompt information:
HEX instruction mode ： FF FF
AT instruction mode ： Builded network<CR><LF>
3 Devices joining the network will prompt information
HEX instruction mode： FF AA
AT instruction mode： Joined network<CR><LF>